Abstract
This specification covers cutback petroleum asphalts of the rapid-curing type for use in the construction and treatment of pavements. The cutback asphalt shall not foam when heated to application temperature and shall conform to the requirements prescribed for the following: (1) kinematic viscosity, (2) flash point, (3) distillate content, (4) amount of residue from distillation, (5) properties of residue from distillation such as viscosity, ductility, and solubility in trichloroethylene, and (6) water content. The properties enumerated shall be determined by the specified test methods including tag open-cup flash point, distillation, and penetration tests.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers cutback petroleum asphalts of the rapid-curing type for use in the construction and treatment of pavements.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Reproduced, with permission, from the ASTM International website, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. To purchase the complete standard, go to http://www.astm.org/.
